Veto Pro Pac Tech-XL Service Technician Bag

MAXIMIZED TOOL STORAGE CAPACITY:

• Vertical Tool Pockets: 80 interior and exterior pockets of various sizes
• Neoprene Pockets: 2 Large, 3 Medium and 9 Small (for bits or memory sticks)
• D-Rings: 4 large and 5 small
• 8” Electrical Tape Strap
• Stainless Steel Tape Clip: Yes

RUGGED MATERIALS & CONSTRUCTION:

• Waterproof Base: 3mm Injection Molded Polypropylene
• Waterproof Body Fabric: 1800 PVC Impregnated Denier Nylon
• Waterproof Tool Pocket Fabric: 1800 PVC Impregnated Denier Nylon
• Handle: Injection Molded Nylon Plastic w/ over-molded ergonomic rubber grip
• Zippers: Double Stitched, Heavy Duty Plastic Coil Zippers with Oversized Zipper Tabs
• Fold-Back Snaps: 6 zinc, marine grade
• D-Rings: Powder Coated Steel
• Rivets: 38 zinc, marine grade rivets
• Stitching: Industrial Strength Double Nylon Stitching

OTHER FEATURES:

• Shoulder Strap: Extra-Wide, Heavy Duty, Padded Shoulder Strap Clips onto Handle
• Warranty: 5 Years (see Veto warranty terms and conditions)

Veto Pro Pac Tool Bags Product Care and Maintenance

Keep the Zippers Clean & Lubricated

Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.

Protect the Zippers From Sharp Objects and/or Excessive Heat

Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Don’t Overstuff the Bag

Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!

• 80 Vertical Tool Pockets
• 2 Large, 3 Medium & 9 Small Neoprene Pockets
• 4 Large and 5 Small D Rings
• Stainless Steel Tape Clip
• 3 MM Water Proof Injection Molded Polypropylene Base
• 1800 PVC Impregnated Denier Nylon (Waterproof Body Fabric)