Festool Centrotec Drill / Driver Bits
Festool Centrotec Drill and Driver Bits Explained
Festool Centrotec drill and driver bits use a quick-change shank that drops straight into a Centrotec chuck, so you swap from drilling to driving in one motion. This collection gathers the whole Centrotec system: HSS drill bits from 3mm to 10mm, a stubby wood drill bit set, pilotless countersinks, a drill bit with depth stop, Phillips, Pozidriv, Torx, and square driver bits, bit holders, socket adapters, an SDS-Plus adapter, and the 94-piece Systainer3 organizer set.
What to Look For
- The chuck. Centrotec bits need a Centrotec chuck. The 492135 chuck is listed here if your drill does not have one fitted.
- Bit holders. The BHS 60 and BHS 65 holders take standard bits, and the BH 60 holder is built for impact use.
- Length. 2-inch bits keep the drill short, while 100mm bits reach into recesses and cabinet corners.
- Sockets. 1/4-inch and 3/8-inch drive socket adapters turn the drill into a nut driver.
Buy Festool Centrotec bits from The Tool Nut, an authorized Festool dealer and specialty tool store since 1994. Free shipping on all Festool orders, free Festool swag with most orders, and rewards points on every purchase.
Festool Centrotec Drill / Driver Bits FAQ
Where should I start with Centrotec?
The 6-piece Centrotec bit set or the 94-piece Systainer3 organizer set covers the common drive types in one purchase. Add single HSS drill bits and countersinks for the hole sizes you use most.
Can I use Centrotec bits by hand?
Yes. The 200140 Centrotec handle driver accepts the same bits, which helps for final tightening on hinges and hardware where a drill would overdrive the screw.