The Festool 495207 55" Clear Splinterguard (1400mm) is a replacement splinter guard for Festool guide rails. This is a guide rail accessory designed for maintaining clean, accurate track-guided cuts. Model Number 495207. If your original edge strip is worn, nicked, or no longer matched to your current blade, replacing it helps restore the guide rail's cut-line reference and reduce tear-out.

What matters here is not just that it is a replacement part, but what that replacement does on the job. A fresh splinterguard can be trimmed to match the saw blade you're using, which gives you a more precise visual reference right at the cut line. That means less second-guessing during setup and fewer surprises once the cut is made. Festool also calls out that this is especially useful when switching between different kerf blades or using more than one saw on the same rail.

The clear design is a practical upgrade over an opaque edge strip because it improves visibility while you line up the rail. On sheet goods, finished plywood, veneered panels, and other materials where cut placement matters, being able to see the line through the splinterguard helps speed up setup without giving up accuracy.

This part also plays a direct role in cut quality. The splinterguard supports the fibers right at the blade path, which helps limit tear-out on cuts with the grain and across it. When the strip gets chewed up from heavy use, that support is reduced. Replacing it is one of those small maintenance moves that keeps a track saw system cutting the way it should.

Compatibility is straightforward. This splinter guard is suitable for Festool FS/2, FS/2 KP, and FSK guide rail systems, and the included length is 55 inches or 1400 mm. That makes it a fit for users already running Festool guide rails who want to keep their rail aligned properly to the blade and maintain splinter-free cutting performance.

Who should buy it? Anyone using a Festool track saw and guide rail setup for finish carpentry, cabinet work, interior trim, or sheet-good breakdown will get the point immediately. If you care about accurate rail placement, clean edges, and repeatable results, this is not filler in the system. It is a wear item that directly affects cut quality.

Festool 495207 55" Clear Splinterguard (1400mm) is a small part that does real work

If your guide rail cuts are starting to lose that clean, dead-on edge, this replacement is one of the easiest ways to get your system back where it should be.

• Who it's for: Festool guide rail and track saw users who care about clean edges, accurate cut-line setup, and finish-quality results.
• Why it stands out: The clear strip improves visibility and gives you a fresh edge that can be matched to your blade for better alignment and splinter control.
• Worth knowing: This is a wear item, not a flashy accessory. But when the original strip is worn, you will notice the difference in setup accuracy and cut quality.

• What is this part used for? It is a replacement splinterguard for Festool guide rails, used to improve cut-line alignment and help reduce tear-out during track-guided cuts.
• Which guide rails does it fit? Festool lists it as suitable for FS/2, FS/2 KP, and FSK guide rails.
• Why replace the splinterguard? Festool recommends replacement after heavy use, especially when switching between different kerf blades or using more than one saw with the same guide rail.
• What length is this splinterguard? It is 55 inches long, which is 1400 mm.