The Kreg Tool KHI-XLPULL cabinet hardware installation jig is a cabinet hardware installation jig designed for fast, repeatable placement of large pulls and knobs on cabinet doors and drawer fronts. Model Number: KHI-XLPULL. If you install a lot of hardware and want cleaner results with less layout time, this is the kind of jig that earns its spot in the toolbox.

What matters here is consistency. The ruler-based layout lets you position hardware with repeatable spacing, then carry that setup across multiple parts. On cabinet work, that means fewer measuring mistakes, fewer re-drilled doors, and a more professional finished look. The images also show the jig in use on both doors and drawer fronts, so its job is clear: set hardware locations accurately and keep them consistent from piece to piece.

The KHI-XLPULL is aimed at larger pulls as well as knobs, which makes it especially useful when exact hole spacing matters. Long cabinet pulls can look off fast if one side drifts even a little. A dedicated hardware jig helps keep the pull centered, level, and matched across an entire run of cabinetry.

Construction is a big part of the value here. Kreg calls out thick, durable, all-aluminum construction, and that matters because a hardware jig only works if it stays rigid and trustworthy over time. A flimsy jig can flex, shift, or lose confidence after a few installs. Aluminum gives this one a more shop-grade feel for repeated use in cabinet installs, remodel work, or production-style furniture building.

Another practical feature is the reversible setup for left and right doors. That sounds simple, but on a real install it saves time. Instead of fighting a one-direction jig or improvising measurements from side to side, you can move through a bank of doors with less downtime and less chance of mixing up orientation.

This tool makes the most sense for cabinet installers, finish carpenters, remodelers, custom furniture builders, and serious DIY users who care about clean hardware alignment. If you only install one knob once in a while, a tape measure may get you by. If you are doing a kitchen, bath, built-in, or a whole run of drawers and doors, a dedicated cabinet hardware jig like this is the faster and safer way to get uniform results.

Why the Kreg Tool KHI-XLPULL Cabinet Hardware Installation Jig Makes Sense

If you install more than a handful of cabinet pulls, this jig is a lot smarter than chasing measurements with a tape and hoping every hole lands where it should.

• Who it's for: Cabinet installers, trim carpenters, remodelers, furniture builders, and DIY users doing full kitchens, baths, or built-ins.
• Why it stands out: The all-aluminum build, reversible left-right setup, and focus on large pulls make it practical for real repeat work.
• Worth knowing: What sells this tool is speed and consistency, not complexity. If you are only hanging one knob once a year, it is probably more jig than you need.

• What is this tool used for? It is used to position and drill cabinet hardware locations for pulls and knobs on cabinet doors and drawer fronts.
• Can it be used on both left and right cabinet doors? Yes. The product images state that it is reversible for left and right doors.
• Is this meant for larger cabinet pulls? Yes. The product images specifically call out fast installation for large pulls and knobs.