Festool 499810 Radius Router Bit 1.5mm is a carbide-tipped radius router bit made for finishing edge banding with a small, clean roundover. This is a radius router bit designed for routing a 1.5 mm profile on wood or plastic edge banding. Model Number 499810. If you are using a Festool edge router setup and need repeatable results on thin edging, this bit is built for that exact job.

The big story here is precision. With a 1.5 mm radius, 28 mm diameter, and 3 mm cutting length, this bit is set up for edge banding work where too much profile would look wrong and too little leaves the edge feeling sharp. It is meant to dial in that finished, factory-style edge on banded panels rather than act like a general-purpose roundover bit for thick stock.

Festool also went with indexable cutters instead of a basic fixed cutting edge. The two cutters can be rotated to give you four usable cutting surfaces, which matters if you do production edge work or just do not want to toss a bit the second one edge starts to wear. That saves downtime, keeps your profile quality more consistent, and makes the bit a smarter long-term buy for shop use.

The 8 mm shank matches the compatible Festool router lineup this bit is intended for, and the overall 55 mm length gives it the proper geometry for controlled edge profiling. On this kind of work, stability matters. You are not hogging out material. You are trying to leave a clean, even finished edge on visible surfaces, and the bit design reflects that.

For users already in the Festool system, compatibility is straightforward. Festool lists this bit for the OF 900, OF 1000, OF 1010, OF 1010 R, MFK 700, and MFKC 700. It is especially relevant for trim and edge work where the router is being used to refine edge banding on cabinet parts, panels, and finished components.

This bit makes the most sense for cabinet installers, finish carpenters, millwork shops, and serious woodworkers who want clean edge-banding results without trial and error. If your work includes veneered panels, edgebanded plywood, or plastic laminate edging, this is a purpose-built accessory that does one job very well. If you need a bit for heavier roundovers on thick stock, this is probably too specialized. If you need a clean 1.5 mm edge profile on banding, it is exactly the right tool.

Festool 499810 Radius Router Bit 1.5mm is a specialist, and that is the whole point

If you do edge banding work regularly, this bit solves a very specific finishing problem with the kind of repeatability that makes custom work look dialed in.

• Who it's for: Cabinet guys, trim carpenters, and woodworkers using compatible Festool routers for edge-banding and panel finishing.
• Why it stands out: The 1.5 mm profile is purpose-built for thin edge banding, and the rotating carbide cutters give you more life than a one-and-done bit.
• Worth knowing: This is not a general roundover bit for thicker stock. It is a dedicated edge-finishing cutter, so it shines when you use it for the job it was designed to do.

• What does this router bit cut? It is designed to produce a 1.5 mm radius on wood or plastic edge banding.
• Does it use replaceable cutting edges? Yes. The bit uses indexable cutters that can be rotated, giving four usable cutting surfaces.
• What shank size does it use? It has an 8 mm shank.
• Which Festool routers is it listed for? Festool lists it for the OF 900, OF 1000, OF 1010, OF 1010 R, MFK 700, and MFKC 700.