The Kreg 7-1/4-in. SureCut Ultra Fine Finishing 60-Tooth Saw Blade is the top-of-the-line finishing blade for a standard circular saw, built for cabinetry and fine woodworking where the cut edge can't have any tear-out at all. Model number KSB725UFF60. This is the blade for veneered plywood, melamine, and hardwood surfaces that will be seen in the finished piece with no sanding or edge-banding to hide an imperfect cut.

60 teeth on a 7-1/4 in. plate is a significantly finer grind than the 40-tooth finishing blade in this same SureCut line, and it shows up specifically in how the blade handles veneer and composite panel edges. Where a 40-tooth blade can still leave minor chipping on a delicate veneer face, the additional 20 teeth on this blade shear the material in smaller increments, which is what keeps the veneer's face layer intact through the cut.

That level of detail comes with real tradeoffs worth knowing about going in: a 60-tooth blade removes less material per rotation, which means a slower, more deliberate feed rate than a general-purpose blade, and it's more sensitive to feed pressure — pushing too hard is more likely to cause burning on a fine-tooth blade than a coarse one. The PTFE anti-stick coating is doing extra work here for exactly that reason, keeping the plate clean so the blade can cut at the slower speeds this tooth count demands without overheating.

The anti-vibration relief cuts matter more on a high-tooth-count blade too — more teeth engaging the material means more total cutting contact, which is inherently more prone to chatter than a low-tooth-count blade. The relief-cut body keeps this plate stable despite that.

Fits a standard 5/8 in. arbor with a 1.5 mm kerf, the common fit across corded and cordless 7-1/4 in. circular saws.

Who should buy this: cabinet builders, fine woodworkers, and finish carpenters cutting veneered plywood, melamine, and hardwood where the edge is the finished surface. For general trim and everyday plywood work, the 40-tooth finishing blade in this line is the more practical, faster-cutting choice — save this blade for the cuts that truly need it.

For the cut where chipped veneer isn't an option

This is the specialty blade in the SureCut line — 60 teeth for the cabinetry and fine woodworking cuts that can't afford tear-out.

• Who it's for: Cabinet builders and fine woodworkers cutting veneered plywood, melamine, and hardwood on a standard circular saw.
• Why it stands out: The finest tooth count in the lineup, paired with anti-stick coating and vibration-damping relief cuts.
• Worth knowing: Slower feed rate than a general-purpose blade — for everyday plywood and trim, the 40-tooth finishing blade will get the job done faster.

• How is this different from the 40-tooth finishing blade? This 60-tooth blade is a finer grind, built specifically to prevent chipping on veneered plywood and delicate hardwood — the 40-tooth blade is the faster, general finishing choice.
• Will this blade cut slower than a standard blade? Yes — the higher tooth count is built for finish quality, and it wants a slower, steadier feed rate than a coarser blade.