The Kreg Tool KCS-DFMT-PRO Drawer Front Mounting Jig Tool System is a cabinet installation jig built to help you mount and align drawer fronts quickly and consistently. This is a drawer front mounting system designed for mounting and aligning drawer fronts during cabinet building, renovation, and repair. Model Number: KCS-DFMT-PRO. If you build cabinets for a living or just want cleaner results in the shop, this setup takes a frustrating two-hand task and turns it into a controlled, repeatable process.

What matters here is not just that it clamps. It clamps while giving you reference points that actually help you place the front where it belongs. The alignment marks make fine positioning easier, and the included setup and spacer shims help you establish consistent gaps and reveals instead of eyeballing them. That is the difference between a drawer bank that looks custom and one that looks close enough.

Kreg built this system around thick steel with ribbed corners to resist flex. That matters when you are tightening against a drawer front and need the jig to stay put instead of shifting under pressure. Large clamp pads and the GripMaxx anti-slip surface help the tool hold steady while protecting control at the contact points, and the oversized knobs make adjustment easier when you are moving through multiple drawers in a row.

This setup is also practical for real shop and jobsite work because it reduces the need to hold the front in place by hand while fastening. On a one-off vanity, that saves aggravation. On a full kitchen or built-in project, it saves time across every drawer. The system works with drawers that have 3/8 inch side clearance and supports drawer front overlays up to 1-1/2 inches on each side, so it fits a useful range of common cabinet layouts.

The included shim set is a big part of why this system is more than just a pair of clamps. You get seven setup and spacer shims in multiple thicknesses, including inset and stackable options, so you can dial in repeatable spacing instead of hunting for scraps or making improvised spacers. That is especially useful when you are matching reveals across several drawers and want the second, third, and tenth front to land like the first one.

Material-wise, the clamps use steel with durable plastic polymer knobs, while the setup and spacer shims use durable plastic polymer and rare-earth magnets. The magnets help keep the shim system organized and ready to grab, which sounds small until you are moving fast through install work and do not want loose spacers disappearing into a toolbox or shop apron.

This drawer front mounting system is best suited for cabinet makers, trim carpenters, remodelers, finish carpenters, and serious DIY users building or refacing cabinets. If you install a lot of drawer fronts and want a cleaner, more repeatable setup than improvised clamps and scraps, this is the kind of jig that earns its space quickly.

Why the Kreg Tool KCS-DFMT-PRO Drawer Front Mounting Jig Tool System earns its keep

This is a smart cabinet jig for anyone tired of balancing drawer fronts by hand and hoping the reveal stays even.

• Who it's for: Cabinet makers, finish carpenters, remodelers, and serious DIY users installing multiple drawer fronts.
• Why it stands out: The steel body stays rigid, the alignment marks make setup faster, and the shim system helps repeat clean spacing instead of improvising with scraps.
• Worth knowing: This tool shines most when you have several fronts to install. If you only hang one drawer front a year, it may feel specialized. If you do cabinet work regularly, it is the kind of specialized tool that saves real time.

• What is this tool used for? It is used to mount and align drawer fronts during cabinet building, renovation, or repair.
• Will it work with overlay drawer fronts? Yes. It supports drawer front overlays up to 1-1/2 inches on each side.
• What drawer clearance does it require? It works with drawers that have 3/8 inch clearance on the sides.
• Is the body heavy-duty or light-duty? It uses thick steel construction with ribbed corners to resist flex.