Festool 201182 Parallel Guides For Guide Rail System, Imperial is a parallel guide accessory set for Festool FS guide rails. This is a guide rail cutting accessory designed for precise, repeatable rip cuts in sheet goods and panel stock. Model Number: 201182. If you use a Festool track saw and want to stop laying out the same dimension over and over, this setup is built to speed that process up while keeping cuts consistent.

The big value here is simple: set your width once, register the adjustable stops against the edge of the material, and make repeat cuts with much less measuring and marking. Festool rates the system as adjustable to 26" (650 mm), which puts it right in the sweet spot for common cabinet parts, shelving, fillers, and trim-down work on larger panels. For anyone cutting multiples, that repeatability is the reason to buy it.

Festool includes two adjustable stops that engage the edge parallel to the cut. In real use, that means the guide rail is positioned off the workpiece edge in a controlled, repeatable way instead of being set by tape measure each time. That helps reduce setup time and helps keep finished parts matching from piece to piece, especially when accuracy matters more than raw speed.

The imperial format is worth calling out because it makes sense for users who work in inch-based measurements all day. If your plans, cut lists, and layout workflow are already in inches, using an imperial parallel guide setup keeps the process straightforward and cuts down on conversion mistakes that waste material.

This accessory is not a standalone cutting solution. It is meant to be part of a Festool FS guide rail system, and the guide rail itself is not included. That is important because buyers need to know this adds capability to an existing rail-based saw setup rather than replacing the rail. If you already own the rail and use it regularly for plywood, melamine, or other panel work, these guides make the system much more efficient for parallel cuts.

Who is this for? Cabinet installers, finish carpenters, shop woodworkers, remodelers, and serious DIY users who break down sheet goods and need consistent widths without building a shop jig every time. If you only make occasional rough cuts, this may be more accessory than you need. If you cut panels often and want cleaner workflow with fewer setup errors, it is the kind of add-on that earns its spot pretty quickly.

Festool 201182 Parallel Guides For Guide Rail System, Imperial Make a Track Saw Setup More Productive

This is the kind of accessory that makes a good guide rail system feel a lot more like a production tool when you are cutting repeat widths.

• Who it's for: Woodworkers, cabinet installers, and remodelers who already use Festool FS rails and need repeatable panel cuts without extra layout time.
• Why it stands out: The adjustable stop setup is all about consistency. Once it is dialed in, you can knock out matching rips faster and with less measuring.
• Worth knowing: This is an accessory, not a complete rail system. The FS guide rail is not included, so it makes the most sense for users already invested in Festool track saw workflow.

• What is this product used for? It is used to make precise, repeatable rip cuts by setting the cut width from the edge of the workpiece on a Festool FS guide rail setup.
• What is the maximum adjustment range? The guides adjust up to 26" (650 mm).
• Does it work by itself? No. It is designed to work with Festool FS guide rails.
• Is the guide rail included? No. The FS guide rail is not included.