Festool 492243 Parallel Guide for TS 75 is an accessory built to turn your TS 75 into a more controlled ripping setup. This is a parallel guide designed for parallel rip cutting with the Festool TS 75 plunge cut saw. Model Number 492243. If you need repeatable cuts at a set distance from the edge of the workpiece, this guide gives you that control without needing to run on Festool FS guide rails.

The main advantage here is speed and consistency. Instead of measuring and marking every cut or setting up a rail for narrower rips, the guide lets you register off the edge of the material and keep your cut line parallel. Festool states it can be used for parallel cutting independent of the FS guide rails, which is the whole point of this accessory. For cabinet parts, trim stock, sheet breakdown, or jobsite fitting work where you need a clean repeated dimension, that saves time and cuts down on setup.

It also gives you flexibility in how you set the saw up. The guide attaches to both sides of the TS 75, so you can configure it for short side or broad side cuts. On the blade side, rip capacity goes up to 12" (300 mm). On the motor side, capacity goes up to 3-3/4" (95 mm). That matters because not every cut or workpiece layout favors the same side of the saw. Having both options makes the saw easier to work with in tighter conditions or when you are trying to keep the motor positioned out of your way.

Festool built this accessory from aluminum and steel, which is what you want in a guide that needs to stay straight and hold its setting. A flimsy guide defeats the whole purpose. The included through bolts and clamp are there for quick setup, so you are not piecing together hardware or fighting with an awkward installation before you can get to work. Festool also notes it can be used as a table extension, which adds a little more support value beyond basic edge guiding.

From a jobsite practicality standpoint, this is a smart add-on for owners of the TS 75 who want more out of the saw without overcomplicating the setup. It is not a replacement for guide rails when you are making long precision track-guided cuts across sheet goods, but it is a very useful accessory when the job calls for edge-referenced ripping and repeated dimensions. Different tool, different job. Used the right way, this fills a real gap.

This accessory is specifically suitable for the Festool TS 75 platform. If you already run that plunge cut saw and want faster parallel cutting, this is the kind of add-on that earns its keep. It makes the most sense for carpenters, remodelers, installers, and woodworkers who regularly trim material to width and want cleaner workflow than a tape-and-pencil approach.

Festool 492243 Parallel Guide for TS 75 is the right add-on if you want your saw to do more than track cuts

This is a practical accessory that makes the TS 75 faster and more repeatable for edge-guided rip work.

• Who it's for: TS 75 owners doing cabinet parts, trim-to-width cuts, remodeling, and shop work where repeatable parallel cuts matter.
• Why it stands out: It works without FS guide rails, mounts to either side of the saw, and gives useful rip capacity depending on how you set it up.
• Worth knowing: This is a saw accessory, not a standalone cutting system. If your work is mostly long rail-guided sheet cuts, you will still want your guide rails. For quick edge-referenced rips, though, this is a smart piece to have.

• Does this parallel guide require Festool FS guide rails? No. Festool states it enables parallel cutting with the TS 75 independent of the FS guide rails.
• What saw does this fit? It is suitable for the Festool TS 75 plunge cut saw.
• Can it be mounted on either side of the saw? Yes. It can be used on both sides of the saw for short side and broad side cuts.
• What is the maximum rip capacity? Capacity is up to 12" (300 mm) on the blade side and up to 3-3/4" (95 mm) on the motor side.