The Snappy 93008 1/8" X 3/8" Countersink is a drilling and countersinking accessory made for clean screw prep in wood. This is a countersink designed for drilling a pilot hole and cutting a countersink for standard screws. Model Number: 93008. If you use a Festool Centrotec setup and want one accessory that gets the hole ready for the screw head in a single pass, this is the right type of bit for the job.

The working end combines a 1/8 inch diameter high speed steel twist drill with a 3/8 inch x 82 degree countersink. In practical terms, that means you can bore the pilot hole and seat the screw head flush without swapping between separate bits. That saves time on cabinet parts, trim work, face frames, and general woodworking where repeatable screw placement matters.

The Festool Centrotec compatible shank is the big reason a lot of users buy this model. It is built to work with Festool Centrotec keyless chucks, so bit changes are quick and the setup stays compact. That matters when you are moving between drilling, countersinking, and driving on the same piece.

Snappy sizes this countersink around common wood screw work. It is recommended for #8 screws in hardwood and #10 screws in softwood. That gives you a good target range for furniture, finish carpentry, and shop projects where you want the screw to pull tight without splitting the material or leaving the head proud.

Serviceability is another plus. The listed replacement twist drill is Snappy 49208, which is useful if you wear out the pilot bit before the countersink body. It also works with Snappy's Premium Rotating Stop Collar if you want better depth control for repetitive work.

This is a strong fit for woodworkers, trim carpenters, cabinet installers, and serious DIY users already invested in the Festool Centrotec platform. If you need a compact countersink for clean fastening in wood and you want Centrotec-compatible convenience, the Snappy 93008 1/8" X 3/8" Countersink makes a lot of sense.

Snappy 93008 1/8" X 3/8" Countersink Keeps Centrotec Users Moving

This is a straightforward, job-useful countersink that does exactly what a Festool Centrotec user wants: quick changes, clean pilot holes, and screw seats that look right.

• Who it's for: Woodworkers, cabinet installers, trim carpenters, and serious DIY users running Festool Centrotec chucks.
• Why it stands out: The Centrotec-compatible shank plus the 1/8 inch drill and 3/8 inch 82 degree countersink make it a practical one-step setup for common wood screw work.
• Worth knowing: This one is sized around #8 screws in hardwood and #10 screws in softwood, so match it to that range if you want the best results.

• What kind of chuck does this countersink fit? It is made with a Festool Centrotec compatible shank for use with Festool Centrotec keyless chucks.
• What screw sizes is it recommended for? Snappy recommends it for #8 screws in hardwood and #10 screws in softwood.
• Can the pilot drill be replaced? Yes. The listed replacement twist drill is part number 49208.
• What does the cutting setup include? It uses a 1/8 inch diameter high speed steel twist drill and a 3/8 inch countersink with an 82 degree angle.