The SawStop CB104 184 60-Tooth 10 in. Combination Table Saw Blade is a carbide-tipped 10 inch table saw blade built for wood cutting where a cleaner finish matters. This is a table saw blade designed for precision cutting in softwood and hardwood. Model Number: CB104 184. If you want a blade that leans toward smoother results instead of rough construction-grade cuts, this is the kind of setup you reach for.

The key working specs are straightforward and useful: a 60-tooth count, alternate top bevel tooth configuration, 5/8 inch arbor, 0.118 inch kerf, and a maximum speed rating of 5,500 RPM. In real use, that combination points to more refined cutting performance in wood than you would expect from a lower-tooth general framing blade. The alternate top bevel grind is a proven choice when you want better edge quality, and the 60-tooth layout helps the blade leave a cleaner surface on both soft and hard woods.

SawStop also built this blade around practical jobsite concerns, not just catalog numbers. The steel body is heat treated for durability, and the plate is precision balanced to help the blade track more smoothly through the cut. That matters because a blade that runs true is easier to control, puts less strain on the saw, and gives you more consistent results from one pass to the next.

Expansion slots are another feature worth paying attention to here. They are designed to reduce vibration, noise, and heat buildup while cutting. That is not just a comfort feature. Less vibration can mean a steadier cut, less chatter in the material, and better finish quality. Less heat buildup also helps when you are making repeated cuts and do not want cut performance dropping off as the blade warms up.

This blade is made for cutting wood, specifically precision crosscuts in both soft and hard wood. That makes it a solid fit for woodworkers, finish carpenters, cabinet installers, and serious DIY users who care about cut quality on visible parts. It is also a sensible upgrade for anyone still using a rougher stock blade and wondering why finished cuts need more cleanup than they should.

Fit matters with any blade purchase, and the important numbers here are clear: 10 inch diameter and 5/8 inch arbor. If your saw is designed to accept that blade size and arbor size, this SawStop blade lands right in the sweet spot for clean wood cutting. The 0.118 inch kerf and carbide-tipped design round it out as a serious replacement blade for users who want accuracy, smoother performance, and less wasted time fixing rough cuts after the saw is off.

Why the SawStop CB104 184 60-Tooth 10 in. Combination Table Saw Blade Earns Its Spot

This is a smart pick for woodworkers and trim-focused users who want a cleaner cut from a 10 inch table saw blade without overthinking the spec sheet.

• Who it's for: Anyone cutting hardwood or softwood on a table saw and wanting better finish quality than a rough stock blade usually gives.
• Why it stands out: The 60-tooth ATB design, precision-balanced plate, and vibration-reducing expansion slots all point in the same direction: smoother wood cuts and more controlled performance.
• Worth knowing: This is a single blade only, and fit comes down to your saw accepting a 10 inch blade with a 5/8 inch arbor.

• What material is this blade designed to cut? This blade is designed for cutting wood, including softwood and hardwood.
• What is the arbor size? The arbor size is 5/8 inch.
• What is the maximum RPM rating? This blade is rated for up to 5,500 RPM.
• What tooth pattern does it use? It uses an Alternate Top Bevel, also called ATB, tooth configuration.