Woodpeckers DPP Drill Press Protractor

Not Just for Drill Presses!

Woodpeckers introduces the Drill Press Protractora deceptively simple tool that delivers a high level of accuracy when setting angles on your drill press, or other critical tools in your shop. It's a big step for a woodworker to walk away from a straight and square, and start incorporating angles in joinery and design. Setting angles accurately on tools and jigs represents a huge part of the challenge.

The Drill Press Protractor uses a vernier scale to let you set an angle as precisely as 5 minutes of a degree, while reading engraved lines that are widely spaced and easy to see. Once you have your angle set, just mount the Drill Press Protractor in your chuck and adjust the table to match. Whether you're tackling splayed leg chairs and stools, or adding a mid-century modern look to a coffee table or credenza, the Drill Press Protractor makes sure you're angles are spot on.

You have your choice of degrees, minutes, or quarter-degree graduations. Just turn the venier over to change the scale. The vernier allows you to set small fractions of a degree using a scale where the lines are widely spaced and easy to see (instead of crammed together so tight you can't tell one from the other).

"Tramming" your drill press has never been simpler. Returning your drill press to square can be just as setting an angle in the first place. But with the Drill Press Protractor, it's remarkably simple. Just set the DPP to 0 degrees, adjust your table to match, and lock. For verification, turn the chuck by hand and make sure it doesn't bind at any point.

Every try to drill a dowel right on its centerline" The vee machined into the base of the DPP makes it a simple setup. Just bring the vee down onto the dowel and help it "float" into position. Clamp the dowel down and exchange the DPP for your drill bit. Boom...right on the centerline.

Don't get boxed in by the name. While Woodpeckers calls this the Drill Press Protractor, that's only just the beginning of this tool. For instance, miter gauge scales are notoriously inaccurate. You can set any angle perfectly on your miter gauge by setting the angle on your DPP, then aligning the shaft to the miter bar and the DPP base to the face of the miter gauge.

Like all Woodpeckers products, the Drill Press Protractor is precisely machined and carefully inspected in its Strongsville, Ohio facility just south of Cleveland. Woodpeckers builds its tools using stainless steel, anodized aluminum, and stainless hardware so you're assured a lifetime of peak performance.